Seltos Manual
Search by Title only
Home > Safety features of your vehicle > Seat > Headrest (for front seat)

Headrest (for front seat)

The driver's and front passenger's seats are equipped with a headrest for the occupant's safety and comfort.

The headrest not only provides comfort for the driver and front passenger, but also helps protect the head and neck in the event of a collision.

WARNING
  • For maximum effectiveness in case of an accident, the headrest should be adjusted so the middle of the headrest is at the same height of the centre of gravity of an occupant's head. Generally, the centre of gravity of most people's head is similar with the height of the top of their eyes. Also, adjust the headrest as close to your head as possible. For this reason, the use of a cushion that holds the body away from the seatback is not recommended.

  • Do not operate the vehicle with the headrests removed or reversed as severe injury to the occupants may occur in the event of an accident. Headrests may provide protection against neck injuries when properly adjusted.

  • Do not adjust the headrest position of the driver's seat whilst the vehicle is in motion.

Adjusting the height up and down

To raise the headrest:

  1. Pull it up to the desired position (3).

  2. To lower the headrest, push and hold the release button (2) on the headrest support.

  3. Lower the headrest to the desired position (1).

WARNING

Make sure the headrest locks in position after adjusting it to properly protect the occupants.

CAUTION

If you recline the seatback towards the front with the headrest and seat cushion raised, the headrest may come in contact with the sun visor or other parts of the vehicle.

Removing headrest

Type A
Type B

To remove the headrest:

1
Recline the seatback (2) with the recline lever or switch (1).
2
Raise headrest as far as it can go.
3
Press the headrest release button (3) whilst pulling the headrest up (4).
WARNING

NEVER allow anyone to ride in a seat with the headrest removed.

Reinstalling headrest

Type A
Type B

To reinstall the headrest:

1
Put the headrest poles (2) into the holes whilst pressing the release button (1).
2
Recline the seatback (4) with the recline lever or switch (3).
3
Adjust the headrest to the appropriate height.
WARNING

Always make sure the headrest locks into position after reinstalling and adjusting it properly.