Forward/Reverse Parking Distance Warning (PDW) (if equipped)
The sensing range and objects detectable by the ultrasonic sensors (1) are limited. Whenever moving whilst using Forward/Reverse Parking Distance Warning, pay as much attention to what is in front and behind you as you would in a vehicle without Forward/Reverse Parking Distance Warning.
Forward/Reverse Parking Distance Warning should only be considered as a supplementary function. The driver must check the front and rear view. The operational function of Forward/Reverse Parking Distance Warning can be affected by many factors and conditions of the surroundings, so the responsibility rests always with the driver.
Operation of Forward/Reverse Parking Distance Warning
-
This function activates when the Parking Safety button is pressed with the ENGINE START/STOP button ON.
-
The indicator of the Parking Safety button turns on automatically and activates Forward/Reverse Parking Distance Warning when you shift the gear to the R (Reverse) position.
-
The sensing distance whilst backing up is approximately 100 cm when you are driving less than 10 km/h.
-
The sensing distance whilst moving forward is approximately 100 cm when you are driving less than 10 km/h.
-
When more than two objects are sensed at the same time, the closest one will be recognised first.
-
The ultrasonic sensors are activated when you shift the gear to the R (Reverse) position.
-
If the vehicle speed is above 30 km/h, the function automatically turns off. To activate again, push the button.
It may not operate if it's distance from the object is already less than approximately 30 cm when the function is ON.
|
Distance from object |
Warning indicator |
Warning sound |
||
|---|---|---|---|---|
|
When driving forward |
When driving backward |
|||
|
60 ~ 100 cm |
Front |
 |
 |
Buzzer beeps intermittently |
|
Rear |
- |
Buzzer beeps intermittently |
||
|
30 ~ 60 cm |
Front |
 |
 |
Buzzer beeps frequently |
|
Rear |
- |
Buzzer beeps frequently |
||
|
within 30 cm |
Front |
 |
 |
Buzzer beeps continuously |
|
Rear |
- |
Buzzer beeps continuously |
||
-
The actual warning sound and indicator may differ from the illustration depending on the objects or sensor status.
-
Do not wash the vehicle's sensor with high pressure water.
-
This function can only sense objects within the range and location of the sensors; it cannot detect objects in other areas where sensors are not installed. Also, small or slim objects, such as poles or objects located between sensors may not be detected by the sensors.
Always visually check behind the vehicle when backing up.
-
Be sure to inform any drivers of the vehicle that may be unfamiliar with the function regarding the function's capabilities and limitations.
Non-operational conditions of Forward/Reverse Parking Distance Warning
-
Moisture is frozen to the sensor. (It will operate normally when moisture melts.)
-
Sensor is covered with foreign matter, such as snow or water, or the sensor cover is blocked. (It will operate normally when the material is removed or the sensor is no longer blocked.)
-
Sensor is stained with foreign matter such as snow or water. (Sensing range will return to normal when removed.)
-
The Parking Safety button is off.
-
Driving on uneven road surfaces such as unpaved roads, gravel, bumps, or gradient.
-
Objects generating excessive noise such as vehicle horns, loud motorcycle engines, or truck air brakes can interfere with the sensor.
-
Heavy rain or water spray.
-
Wireless transmitters or mobile phones present near the sensor.
-
Sensor is covered with snow.
-
Outside air temperature is extremely hot or cold.
-
Sharp or slim objects such as ropes, chains or small poles.
-
Objects, which tend to absorb sensor frequency such as clothes, spongy material or snow.
-
There are undetectable objects smaller than 100 cm and narrower than 14 cm in diameter.
-
The warning may not sound consistently depending on the speed and shapes of the objects detected.
-
Forward/Reverse Parking Distance Warning may malfunction if the vehicle bumper height or sensor installation has been modified. Any non-factory installed equipment or accessories may also interfere with the sensor performance.
-
Sensor may not recognise objects less than 30 cm from the sensor, or it may sense an incorrect distance. Use with caution.
-
When the sensor is frozen or stained with snow or water, the sensor may be inoperative until the stains are removed using a soft cloth.
-
Do not push, scratch or strike the sensor with any hard objects that could damage the surface of the sensor. Sensor damage could occur.
This function can only sense objects within the range and location of the sensors; it cannot detect objects in other areas where sensors are not installed. Also, small or slim objects, or objects located between sensors may not be detected.
Always visually check in front and behind the vehicle when driving. Be sure to inform any drivers in the vehicle that may be unfamiliar with the function regarding the function's capabilities and limitations.
Pay close attention when the vehicle is driven close to objects on the road, particularly pedestrians, and especially children. Be aware that some objects may not be detected by the sensors, due to the objects distance, size or material, all of which can limit the effectiveness of the sensor. Always perform a visual inspection to make sure the vehicle is clear of all obstructions before moving the vehicle in any direction.
Self-diagnosis
When you shift the gear to the R (Reverse) position and if one or more of the below occurs you may have a malfunction in Forward/Reverse Parking Distance Warning.
-
You don't hear an audible warning sound or if the buzzer sounds intermittently.
-
(blinks) is displayed.
If this occurs, have your vehicle checked by an authorised Kia dealer as soon as possible.
Your new vehicle warranty does not cover any accidents or damage to the vehicle or injuries to its occupants. Always drive safely and cautiously.